Filter
Top Products
3
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DESCRIPTION OF OPERATIONS
3 - 21
[B] Bundle job offset mode/ stapling stack mode
Fig. 3-26
START
Paper jam
Entrance sensor ON?
Entrance motor ON
Exit motor ON
Stapler unit shift motor ON
Stapler unit home position sensor ON
Stapler Interference switch ON
Stapler Interference sensor ON
Patting solenoid ON
Buffer tray guide motor ON
Buffer tray home position sensor ON
Paddle motor ON
Paddle home position sensor ON
NO
Finishing tray paper
detection sensor ON?
Paper jam
YES
NO
Paper holding arm motor ON
Catching solenoid ON
Buffer roller lift solenoid ON
Buffer roller drive motor ON (Reverse)
Buffer tray guide motor ON
Buffer tray home position sensor ON
Paper exit guide clutch ON
Paper exit guide clutch ON
Stack transport motor ON
Stack exit belt home position sensor ON
End
Shutter clutch ON
Transport motor ON
Shutter opening/closing sensor ON
Movable tray shift motor ON
Movable tray paper-full sensor ON
Movable tray shift motor ON (Reverse)
Movable tray position sensor ON
Movable tray upper position sensor ON
Movable tray lower position sensor ON
YES
Buffer roller lift solenoid ON
Paper jam
NO
YES
Transport sensor ON?
Staple stack mode
Front alignment motor ON
Front alignment plate home position sensor ON
Rear alignment motor ON
Rear alignment plate home position sensor ON