Filter
Top Products
4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4 - 9
[M] Front rail cover / Rear rail cover
(1) Take off the movable tray.
P.4-2 "[B] Movable tray"
(2) Open the front cover (MJ-1103) or the front
upper cover and the saddle unit (MJ-1104),
and then remove 1 screw on the left side of
the control panel unit.
(3) Remove 3 screws and slide the front rail
cover upward to unhook it. Then take off the
front rail cover from the main unit by sliding
the left side of the control panel unit toward
you.
Note:
When installing the front rail cover, hang the
3 hooks of the cover on the holes of the
frame.
Fig. 4-24
(4) Remove 2 screws and slide the rear rail
cover upward to unhook it. Then take off the
rear rail cover from the main unit.
Note:
When installing the rear rail cover, hang the 3
hooks of the cover on the holes of the frame.
Note:
After the front and rear rail covers were
installed, check that the movable tray does
not touch with the rail covers by moving it up
and down.
P.4-124 "4.12 Procedure for lowering the
movable tray"
Fig. 4-25
Front rail
cover
Hook
control panel unit
Rear rail
cover
Hook