Filter
Top Products
6
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved MJ-1103/1104
TROUBLESHOOTING
6 - 11
[CC31] Transport motor (M7) abnormality
* The [CC31] error also occurs when the error [ED12] has occurred consecutively for 3
times.
Is there any mechanical problem when the stack transport roller -1 and -2 are rotated?
YES Fix the mechanism.
NO
Is the harness between the transport motor (M7) and the CN10 of the finisher control PC board
(FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the transport motor (M7).
2. Replace the finisher control PC board (FIN).
[CC41] Paper pusher cam home position abnormality
Is there any mechanical problem when the paper pusher cam is rotated?
YES Fix the mechanism.
NO
Is the harness between the paper holder home position sensor (S6) and the CN9 of the finisher
control PC board (FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
1. Replace the paper pusher home position sensor (S6).
2. Replace the finisher control PC board (FIN).
[EA32] Exit paper remaining jam
Is there any paper remaining on the transport path in the finisher or equipment?
YES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the finishing tray
paper detection sensor (S12)?
l
l
YES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the finishing tray paper detection sensor (S129) and the CN18 of the fin-
isher control PC board (FIN) disconnected or open circuited?
l
YES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the finisher control PC board (FIN).