Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 96
[H] Rear alignment plate home position sensor (S8)
[I] Stack exit belt home position sensor (S9)
(1) Take off the grate-shaped guide.
P.4-10 "[N] Grate-shaped guide"
(2) Release the latch, and then disconnect the
connector to take off the rear alignment plate
home position sensor.
Fig. 4-270
(1) Take off the finishing tray unit.
P.4-19 "[D] Finishing tray unit"
(2) Remove 3 screws, and then take off the front
finishing tray cover.
Fig. 4-271
(3) Remove 3 screws, and then take off the rear
finishing tray cover.
Fig. 4-272
Rear alignment
plate home position sensor
Front finishing tray cover
Rear finishing tray cover