Filter
Top Products
MJ-1103/1104 © 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND INSTALLATION
4 - 82
[F] Buffer roller lift solenoid (SOL2) / Patting solenoid (SOL3)
(3) Remove 2 screws, and then take off the
catching solenoid.
Fig. 4-231
(1) Take off the stationary tray.
P.4-1 "[A] Stationary tray"
(2) Close the buffer unit-1.
(3) Release the harness of the buffer roller lift
solenoid and the patting solenoid out of 1
clamp, and then disconnect 2 relay connec-
tors.
Fig. 4-232
(4) Remove 3 screws, and then disconnect the
plunger to take off the 3 spacers, 3 screw
dampers, 2 solenoid dampers and solenoid
sensor unit.
Fig. 4-233
Catching solenoid
Relay
connector
Clamp
Solenoid sensor unit
Spacer
Screw
damper
Solenoid
damper