Filter
Top Products
E6581381
F-14
6
■ Setting of switching terminals
The terminal for switching to motor 2 needs to be set, since this function is not assigned under the default
setting. Assign this function to an idle terminal.
The parameters to be switched depend on the particular identification number of the input terminal selection
function.
Input terminal function number
5
AD2
39
VF2
40
MOT2
61
OCS2
Parameters used and applicable parameters
OFF OFF OFF OFF
Default setting:
RV, XN, XNX, XD, VJT, CEE,
FGE, HU, H
ON OFF OFF OFF
CEE → HU, FGE → H,
H → HU
OFF OFF OFF ON
H → H
OFF ON OFF OFF
RV → , XN → H, XNX → H,
XD → H, VJT → H
--ON-
RV → , XN → H, XNX → H,
XD → H, VJT → H,
H → H, CEE → HU,
FGE → H, H → HU
Note:The parameters XN, XNX, RV, H and H cannot be switched during operation. You need
to stop operation when switching them.
6.5 Frequency priority selection
6.5.1 Using a frequency command according to the particular
situation
HOQF : Frequency setting mode selection 1
H
: Frequency priority selection
H
: Speed setting mode selection 2
• Function
These parameters are used to switch between two types of frequency command signals.
• Setting by parameters
• Switching by frequency
• Switching via terminal board input