Filter
Top Products
E6581381
E-8
5
EOQF : Command mode selection
HOQF
: Frequency setting mode selection 1
• Function
Remote mode selection, these parameters are used to specify which input device (operation panel,
terminal board, serial communication) takes priority in entering an operation stop command or a frequency
setting command, VIA, VIB, operation panel, serial communication device, external contact up/down).
At Local mode selection, the start/stop operation and frequency setting by operation panel is prior with no
relation of EOQF/HOQFsetting.
<Command mode selection>
Title Function Adjustment range Default setting
EOQF Command mode selection
0: Terminal board
1: Operation panel
2: Serial communication
0
Programmed value
:
Terminal board
operation
ON and OFF of an external signal Runs and stops operation.
:
Operation panel
operation
Press the and keys on the operation panel to start and stop.
Serial communication
operation
Run and stop through serial communication.
* There are two types of function: the function that conforms to commands selected by EOQF, and the function
that conforms only to commands from the terminal board.
⇒ See the table of input terminal function selection in Chapter 11.
* When priority is given to commands from a linked computer or terminal board, they have priority over the
setting of EOQF.
STOPRUN