Filter
Top Products
130
PhaserShare Networking Manual
13
Printer Management
PhaserLink Status Notification (Email Notification)
PhaserLink Status Notification allows the printer to automatically send email to the
system administrator and others under the following conditions:
■ When printer errors, warnings, and alerts occur.
■ When the printer requires attention (for example, when service is
required).
■ When a reply to a PhaserLink Remote Internet Printing message is desired.
See the PhaserLink Remote Internet Printing User Manual for more
information on PhaserLink Remote Internet printing.
This status notification capability is supplied by an SMTP (Simple Mail Transport
Protocol) client embedded in the printer’s firmware.
Three designated users can receive messages: SysAdmin, Service, and Key User.
Printer messages reporting errors, alerts, and warnings can be individually assigned
to any of these users. PhaserLink Printer Management Software provides three
pages for controlling email printing:
■ View and Configure PhaserLink Status Notification (Email Notification).
Used to configure status notification parameters such as your email
server’s IP address; addresses for SysAdmin, Service, and Key User
message recipients; and preset subject line and message texts.
■ View and Configure Email Message Settings. Controls which types of
printer conditions generate messages to SysAdmin, Service, and Key User.
■ View and Configure Email Custom Settings. Provides complete control of
notification for every supported printer condition.
For complete information on status notification, including descriptions of all fields
on all three pages, see the PhaserLink software help files.
To display the View and Configure PhaserLink Status Notification (Email
Notification) Settings page
1.
On any PhaserLink page, click Configuration. This displays the View and
Configure Settings page.
2.
From the View and Configure Settings page, click View and Configure
Interface Settings. This displays the View and Configure Interface
Settings page.
3.
On the View and Configure Interface Settings page, click View and
Configure PhaserLink Status Notification (Email Notification) Settings.
This displays the View and Configure PhaserLink Status Notification
(Email Notification) Settings page.