Filter
Top Products
PhaserShare Networking Manual
85
TCP/IP Host Configuration (UNIX)
8
Example installation for a typical BSD UNIX system
The following procedure is an example spooler configuration that will work for
many BSD systems, including SunOS 4.x and 5.x (Solaris 1.x and 2.x) and Digital
UNIX.
Modify the /etc/hosts file to identify the printer to the workstation and modify the
/etc/printcap file to describe the printer to the workstation:
1.
Log on to your system as root.
2.
Make a backup copy of the /etc/hosts file.
3.
Edit /etc/hosts and add a line that defines the printer's IP address and its
name. The IP address you enter here for the printer must be the same
address you specified as the printer's IP address when it was configured.
The name is the name by which your workstation identifies the printer.
(You will enter this same remote name in your /etc/printcap file in the next
step.)
4.
Make a backup copy of the /etc/printcap file.
5.
Edit /etc/printcap and add an entry for your printer. Refer to the following
example and the table “Descriptions of printcap parameters” on page 86 to
create your entry.
N
O
T
E
You need superuser privileges to edit this file.
Example:
134.62.33.138 Phaser740
In this example, 134.62.33.138 is the printer’s IP address and
Phaser740 is the printer’s remote name.
Sample printcap file
# Printer: Tektronix Phaser740
# Print queue name: colorprinter
# Remote machine name: Phaser740
# Remote printer queue name: PS
# Spool directory: /usr/spool/lpd/colorprinter
colorprinter:\
:lp=:\
:rm=Phaser740:\
:rp=PS:\
:mx#0:\
:lf=/usr/spool/lpd/ERRORLOG:\
:sd=/usr/spool/lpd/colorprinter:
#