Filter
Top Products
70
PhaserShare Networking Manual
7
TCP/IP Printer Configuration (All Platforms)
7.
Return the printer to normal operation.
a.
Press Exit (the far left button) until the front panel displays Network
Settings.
b.
Press Exit again.
■ If you have changed any parameters that require a printer reset to
take effect, you will be prompted to reset the printer. If you press
Reset, the printer resets. If you press Resume, the front panel
displays Network Settings. Press Exit (the far left button); the
printer returns to normal operation, but the changes you have made
will not take effect until the next time the printer is reset.
■ If you have not changed any parameters that require a printer reset
to take effect, the front panel displays Ready.
Phaser 780 printer
1.
Press Select; the front panel displays Help Pages.
2.
Press the right arrow or left arrow buttons until the front panel displays
Network Settings.
3.
Press Menu to enter the Network Settings menu.
4.
Press the right arrow button until TCP/IP is displayed.
5.
Press Menu again; the front panel displays Interface.
6.
To disable DHCP/BOOTP:
a.
Press the right arrow button until the front panel displays
DHCP/BOOTP.
b.
Press Menu again to display the current status of the protocol: On or
Off. The current status is marked with an asterisk (*) in the
upper-right corner of the display.
c.
Press the right arrow button until the front panel displays Off.
d.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.
e.
Press Exit (the far right button) to return to the TCP/IP menu.
7.
To return the printer to normal operation, go to Step 8, to disable RARP,
follow these steps:
a.
Press the right arrow button until the front panel displays RARP.
b.
Press Menu again to display the current status of the protocol: On or
Off. The current status is marked with an asterisk (*) in the
upper-right corner of the display.
c.
Press the right arrow button until the front panel displays Off.
d.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.