Filter
Top Products
PhaserShare Networking Manual
163
Disabling Protocols
15
Phaser 360 printer
1.
Press Menu; the front panel displays Help Pages.
2.
Enter the Network Settings menu by pressing ----> or <---- until
the front panel displays Network Settings.
3.
Press Menu; the front panel displays TCP/IP.
4. Disabling TCP/IP:
a.
Press Menu; the front panel displays Enable Interface.
b.
Press Menu again to display the current status of the protocol:
Interface:On or Interface:Off. The current status is marked
with an asterisk (*) in the upper-right corner of the display.
c.
Press ----> until the front panel displays Interface:Off.
d.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays Enable Interface.
e.
Press Exit to return to the TCP/IP display.
5. Disabling EtherTalk (or TokenTalk):
To return the printer to normal
operation, go immediately to Step 8; to continue and disable EtherTalk (or
TokenTalk), follow these steps:
a.
Press ---->; the front panel displays EtherTalk or (TokenTalk).
b.
Press Menu; the front panel displays the current status of the protocol:
Enabled or Disabled. The current status is marked with an asterisk
(*) in the upper-right corner of the display.
c.
Press ----> until the front panel displays Disabled.
d.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays EtherTalk or (TokenTalk).
6. Disabling NetWare:
To return the printer to normal operation, go
immediately to Step 8; to continue and disable the NetWare protocol,
follow these steps:
a.
Press ---->; the front panel displays NetWare.
b.
Press Menu again; the front panel displays Enable Interface.
c.
Press Menu to display the current status of the protocol:
Interface:On or Interface:Off. The current status is marked
with an asterisk (*) in the upper-right corner of the display.
d.
Press ----> until the front panel displays Interface:Off.
e.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays Enable Interface.
f.
Press Exit to return to the NetWare display.