Filter
Top Products
PhaserShare Networking Manual
59
TCP/IP Printer Configuration (All Platforms)
7
c.
Press Select to display the IP address. For example:
d.
Press + to set the left-most digit of the address.
e.
Press ----> to advance to the next digit. Press + to set this digit.
f.
Use ----> and + as described in Step e to set the remaining digits.
g.
When the address is correctly set, press Set to enter your settings into
the printer; the front panel displays:
h.
Press Confirm; the front panel briefly displays Selected, then
returns to TCP/IP Address. The IP address is now set in the printer.
5.
To set the network mask:
a.
Press ----> until Network Mask is displayed.
b.
Press Select; the front panel displays the network mask.
c.
Use + and ----> as described in Steps 4d through 4f to set the
network mask.
d.
When the network mask is set, use Set and Confirm as described in
Steps 4g and 4h to enter the network mask into the printer.
6.
To set the gateway address:
a.
Press ----> until Gateway Address is displayed.
b.
Press Select; the front panel displays the gateway address.
c.
Use + and ----> as described in Steps 4d through 4f to set the
gateway address.
d.
When the gateway address is set, use Set and Confirm as described
in Steps 4g and 4h to enter the gateway address into the printer.
192.2.194.101
+ ----> Set
N
O
T
E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see “Setting IP parameters: RARP or
BOOTP” on page 65).
Confirm Selection
Confirm
N
O
T
E
When you press Confirm to set the IP address, the printer resets the network mask
and broadcast address to the printer’s defaults; see “Printer defaults for network
mask and broadcast address” on page 57.