Filter
Top Products
PhaserShare Networking Manual
21
PhaserShare Series B Network Interfaces
2
Using PhaserLink Printer Management Software to configure Token Ring
For information on connecting to your printer via PhaserLink Printer Management
Software, see “Accessing printer information from a browser” on page 122. For
general information on PhaserLink Printer Management Software, see Chapter 12,
“PhaserLink Printer Management Software”.
1.
From the printer’s home page, click Configuration; this displays the View
and Configure Settings page.
2.
From the View and Configure Settings page, click View and Configure
Interface Settings; this displays the View and Configure Interface
Settings page.
3.
From the View and Configure Interface Settings page, click View and
Configure PhaserShare Settings (Token Ring card); this displays the View
and Configure PhaserShare Settings page for Token Ring.
4.
Enter your settings into the fields for Token Ring Address, Speed, and
Bridging. If you make an error, click Restore Initial Form Values and start
again.
5.
When you are finished entering the settings, enter the Validation Password
and click Do/Apply. If you are not sure of the password, contact your
system administrator.
6.
You must reset the printer before the changes take effect. For more
information, see Chapter 16, “Resetting the Printer”.