Filter
Top Products
PhaserShare Networking Manual
161
Disabling Protocols
15
8.
Return the printer to normal operation:
a.
Press Exit (the far left button) until the front panel displays Network
Settings.
b.
Press Exit (the far left button) again.
■ If you have changed any parameters that require a printer reset to
take effect, you will be prompted to reset the printer. If you press
Reset, the printer resets. If you press Resume, the front panel
displays Network Settings. Press Exit (the far left button); the
printer returns to normal operation, but the changes you have made
will not take effect until the next time the printer is reset.
■ If you have not changed any parameters that require a printer reset
to take effect, the front panel displays Ready.
Phaser 780 printer
1.
Press Select; the front panel displays Help Pages.
2.
Press the left arrow or right arrow buttons until the front panel displays
Network Settings.
3.
Press Menu to enter the Network Settings menu.
4. Disabling TCP/IP:
a.
Press the right arrow button until the front panel displays TCP/IP.
b.
Press Menu; the front panel displays Interface.
c.
Press Menu again to display the current status of the protocol: On or
Off. The current status is marked with an asterisk (*) in the
upper-right corner of the display.
d.
Press the right arrow button until the front panel displays Off.
e.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.
f.
Press the right arrow button twice to return to the Network
Settings menu.
5. Disabling EtherTalk (or TokenTalk):
To return the printer to normal
operation, go immediately to Step 8; to continue and disable the EtherTalk
protocol, follow these steps:
a.
Press the right arrow button until the front panel displays EtherTalk
or (TokenTalk).
b.
Press Menu to display the current status of the protocol: On or Off.
The current status is marked with an asterisk (*) in the upper-right
corner of the display.
c.
Press the right arrow button until the front panel displays Off.
d.
Press Select to disable the protocol; the front panel briefly displays
Selected, then it displays Off again.
e.
Press Exit (the far right button) once to return to the Network
Settings menu.