Filter
Top Products
20
PhaserShare Networking Manual
2
PhaserShare Series B Network Interfaces
6.
Make an entry into the host’s ARP (Address Resolution Protocol) table
defining the printer’s Printer Name/Token Ring address pair. In general,
this requires a command corresponding to one of the following syntax
examples:
7.
Turn on the printer.
8.
Use the host spooling system (for example, lpr or lp) to send the file you
created in Step 3b to the printer; this stores the Token Ring information in
the printer’s internal memory, where it is retained over a reset or power
cycle.
9.
You must reset the printer before the changes take effect. For more
information, see Chapter 16, “Resetting the Printer”.
Using the PhaserShare Administrator to configure Token Ring
1.
In the PhaserShare Administrator Main window, select the desired printer
from the Printer List.
2.
Click Configure Printer; this displays the Configure Printer dialog box.
3.
In the Configure Printer dialog box, click the Token Ring tab.
4.
In the Token Ring tab, set the Token Ring parameters as desired.
5.
Click OK.
6.
You are prompted to reset the printer. You must reset the printer before the
changes take effect. For more information, see Chapter 16, “Resetting the
Printer”.
For more information on the PhaserShare Administrator, see Chapter 5,
“PhaserShare Administrator Software for NetWare Networks”.
arp -s printer-name Token-Ring-address (for BSD systems)
or
arp -s ether printer-nam e Token-Ring-address (for System V)
See the documentation for your host system for specifics of this command.