Filter
Top Products
62
PhaserShare Networking Manual
7
TCP/IP Printer Configuration (All Platforms)
7.
To set the gateway address:
a.
Press the right arrow button until Gateway Address is displayed.
b.
Press Menu; the front panel displays the gateway address.
c.
Use the up arrow and right arrow buttons as described in Steps 5d
through 5f to set the gateway address.
d.
When the gateway address is set, use Set and Confirm as described
in Steps 5g and 5h to enter the gateway address into the printer.
e.
Press Exit (the far right button); the front panel displays:
8.
The printer calculates the broadcast address based on the IP address and
the network mask. However, the broadcast address can be viewed and set
using the following procedure:
a.
Press the right arrow button until Broadcast Address is displayed.
b.
Press Menu; the front panel displays the broadcast address.
c.
Use the up arrow and right arrow buttons as described in Steps 5d
through 5f to set the broadcast address.
d.
When the broadcast address is set, use Select and Confirm as
described in Steps 5g and 5h to enter the broadcast address into the
printer.
e.
Press Exit (the far right button); the front panel displays:
9.
Return the printer to normal operation:
a.
Press Exit (the far right button) until Network Settings appears on
the top line of the display.
b.
Press Exit again.
■ If you have changed any parameters that require a printer reset to take
effect, you will be prompted to reset the printer. If you press Confirm,
the printer resets. To return to normal operation without resetting the
printer, press Exit (the far right button); Printer Menu appears on
the top line of the display. Press Exit again; the printer returns to
normal operation, but the changes you have made will not take effect
until the next time the printer is reset.
■ If you have not changed any parameters that require a printer reset,
press Exit again; the front panel displays Ready.
TCP/IP
Gateway Address Menu
TCP/IP
Broadcast Address Menu