Filter
Top Products
ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
2-213
© 2000, ADC Telecommunications, Inc.
DLP-570
Page 3 of 18
4. Use the arrow or number keys to select Test Access Unit Commands. Press Enter or Return.
The RTAU Configuration screen appears, as shown in Figure 570-3.
14868-A
RTAU CONFIGURATION
1. RTAU Unit Configuration
2. User Pattern Definition
Press CONTROL-A For Assistance
Figure 570-3. RTAU Configuration Menu
Note:
The User Pattern Definition screen is not available for the MPU 5.3 release.
5. Use the arrow or number keys to select RTAU Unit Configuration from the RTAU
Configuration menu. Press Enter or Return. The 'RTAU Config' screen appears, as shown
in Figure 570-4.
Note:
If the
neither
the
RTAU
or
TAU
are plugged into the chassis, the Test Access
Unit Status/Commands screen, shown in Figure 570-5, can still be accessed from the
System Maintenance menu. But in this case it cannot be configured.
However, if the
TAU
is plugged into the chassis, the Test Access Unit Status/Commands
screen
can
be configured after accessing it from the System Maintenance menu. Refer to
the Soneplex Test Access Unit Installation Instructions, listed under Related Publications
at the beginning of this manual, for more information about the TAU.
6. To prepare the RTAU for operation, set the parameters shown on the 'RTAU Config'
screen. Refer to Figures 570-6 through 570-14 for test diagrams and mode schematics.
Refer to Table 570-1 for details regarding parameter options. Use the arrow keys to move
from field to field. Assign the selections by pressing Enter or Return.