Filter
Top Products
Placing Originals
3-7
Basic Sending
3
Orientation
You can place an original either vertically or horizontally. Always align the top edge
of your original with the back edge of the platen glass (by the arrow in the top left
corner), or with the back edge of the feeder.
Platen Glass
Vertical Placement Horizontal Placement
Feeder
Vertical Placement Horizontal Placement
IMPORTANT
•
If the top edge of the original is not aligned with the back edge of the platen glass (by the arrow
in the top left corner), prints may not be made correctly, depending on the mode you have set.
•
If an original is scanned facing the wrong direction, the sender information is not printed
in the correct position on the fax.
NOTE
•LTR originals can be placed either vertically or horizontally. However, the scanning speed
for horizontally placed originals is somewhat slower than for vertically placed originals.
• Horizontally placed LTR originals are referred to as LTR .
• 11" x 17" and LGL originals must be placed horizontally.
•To get the same output result when you are using the feeder as when the original is
placed on the platen glass, place the original upside-down and face up in the feeder.
However, when using the Staple mode, the finisher rotates the output automatically.
Place the
original
face down.
TX Terminal ID
Printed Here
Place the original face down.
TX Terminal
ID Printed
Here
ABC
Place the
original
face up.
TX Terminal ID
Printed Here
ABC
Place the
original
face up.
TX Terminal ID
Printed Here