Filter
Top Products
Configuring System Information 121
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Broadcast Interface Table
.
NOTE: When defining Anycast or Broadcast interfaces, at least one IP address must be defined.
The following is an example of the CLI commands for configuring SNTP interfaces:
Table 6-8. SNTP interface Settings CLI Commands
CLI Command Description
sntp client enable E
nables the Simple Network Time Protocol
(SNTP) broadcast and anycast client on an
interface.
show sntp
configuration
Displays the SNTP configuration.
Console (config)# interface ethernet g1
Console (config-if)# sntp client enable
Console (config-if)# end
Console# show sntp configuration
Polling interval: 7200 seconds.
MD5 Authentication keys: 8, 9
Authentication is required for synchronization.
Trusted Keys: 8,9
Unicast Clients Polling: Enabled.
Server Polling Encryption Key
----------- -------- -----------------
176.1.1.8 Enabled 9
176.1.8.179 Disabled Disabled
Broadcast Clients: Enabled
Broadcast Clients Poll: Enabled
Broadcast Interfaces: g1