Filter
Top Products
Configuring the Switch 67
The system will prompt you with a default answer; by pressing
enter, you accept the default.
After you configure basic settings using the Setup Wizard, you
can manage the device from the Out-of-band management port.
Would you like to enter the setup wizard? [Y/N] Y
1
If [N] is entered, the Setup Wizard is exited. If there is no response within 60 seconds, the
Setup Wizard is automatically exited and the CLI console prompt is displayed. If [Y] is
entered, the Setup Wizard provides interactive guidance through the initial device
configuration.
NOTE: If there is no response within 60 seconds, and there is a BootP server on the network, an address
is retrieved from the BootP server.
NOTE: The user can exit the Setup Wizard at any time by entering [ctrl+z].
Wizard Step 1
If [Y] is entered the following is displayed:
The system is not setup for SNMP management by default. To
manage the switch using SNMP (required for Dell Network
Manager) you can:
•
Setup the initial SNMP version 2 account now.
•
Return later and setup the SNMP version 2 account. (For more
information on setting up a SNMP version 2 account, see the
user documentation).
Would you like to setup the SNMP management interface now?
[Y/N] Y
2
Enter [N] to skip to Step 2 or enter [Y] to continue the Setup Wizard. If [Y] is entered the
following is displayed:
To setup the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access
the switch. The wizard automatically assigns the highest access
level [Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to change this
setting later, and to add additional management system later.
For more information on adding management systems, see the user
documentation.
To add a management station:
Please enter the SNMP community string to be used: