Filter
Top Products
162 Configuring System Information
www.dell.com | support.dell.com
Deleting a DHCP Relay Table Entry
1
Open the
DHCP Relay
page.
2
Click
Show All
to open the
DHCP Servers Table
page.
3
Select a
DHCP Server
and check
Remove
.
4
Click
Apply Changes
.
The entry is deleted, and the device is updated.
Defining DHCP Relay Servers Using CLI Commands
The following table contains the CLI commands for defining DHCP Relay servers.
The following is an example of a CLI command to enable DHCP relay service:
Console (config)# ip dhcp relay enable
Table 6-25. DHCP Relay Server CLI Commands
CLI Command Description
ip dhcp relay
enable
Enables Dynamic Host Configuration Protocol (DHCP)
relay features on the router.
ip dhcp relay
address
ip_address
Sets the DHCP servers available for the DHCP relay.