Filter
Top Products
Configuring the Switch 95
6
Confirm by pressing <Y>.
The following message is displayed:
Erasing flash blocks 1 - 63: Done.
Password Recovery
If a password is lost, use the
Password Recovery
option on the
Startup
menu. The procedure
enables the user to enter the device once without a password.
To recover a lost password for the local terminal only:
1
From the
Startup
menu, select
[4]
and press <Enter>.
The password is deleted.
2
To ensure device security, reconfigure passwords for applicable management methods.
Out-of-Band Management Port
The Out-of-Band (OOB)management port is a 10/100-Mbps Ethernet port that can be used to
connect directly to the switch to perform system administrator management functions. This port is
regarded as a regular IP interface to the system, and all management interfaces are
available over this port.
No inband interfaces can be accessed via the Out-of-Band port. Similarly, the Out-of-Band port
cannot be accessed via the inband ports. Because network management functionality can be
performed using Out-of-Band, you should use the Out-of-Band port for all network management
functions, including Web management; image, boot, and configuration download/upload; Telnet;
SNMP management; and so forth.
Unlike the inband ports, Out-of-Band is not used for routing or switching purposes. Using the Out-
of-Band port rather than an inband port for network management ensures that an additional
inband (1- Gbyte) port remains active for routing.
The following sections contain examples of Out-of-Band commands.
Assigning Dynamic IP Addresses (on an Out-of-Band Port)
console#configure
console(config)#interface out-of-band-eth
console(config-oob)#ip address dhcp hostname dell
console(config-oob)#exit
console(config)#exit
console#