Filter
Top Products
358 Configuring Routing
www.dell.com | support.dell.com
Hello Interval (1-65535)
— Time (seconds) between Hello packets. All devices attached to a
common network must have the same Hello interval. The default is 10 seconds.
Retransmit Interval (0-3600)
— Time (seconds) between link-state advertisement (LSA)
retransmissions for adjacencies belonging to the interface. The value must be greater than the
expected round-trip delay between any two routers on the attached network. The default is 5
seconds.
Transmit Delay(0-3600)
— Estimated time (seconds) required to send a link-state update packet
on the interface. LSAs in the update packet have their age incremented by this amount before
transmission. The default value is 1 second.
Dead Interval (0-2147483647)
— Time (seconds) router Hello packets have not been detected,
and the router times out. The value must be a multiple of the
Hello Interval
value. All routers
attached to a common network must have a value specified for this parameter. The default is 60
seconds.
Virtual Interface State
— Indicates the state of the virtual interface.
Authentication Mode
— The interface authentication type, Password or MD5, used to
authenticate OSPF link state messages.
Authentication Password (1-8 Characters)
— The password (eight characters or less) used to
authenticate OSPF link sate messages.
Authentication Key-Chain
— The MD5 key chain used to authenticate OSPF link sate messages.
Adding a Virtual Link
1
Open the
Virtual Links
page.
2
Click
Add
to display the
Add a Virtual Link
page.
Figure 8-13. Add a Virtual Link Page