Filter
Top Products
316 Configuring Switch Information
www.dell.com | support.dell.com
Figure 7-35. LAG Membership Page
LACP
— Aggregates the port to a LAG, using LACP.
LAG
— Adds a port to a LAG, and indicates the specific LAG to which the port belongs.
Adding a Port to a LAG
1
Open the
LAG Membership
page.
2
Toggle the button under the port number to assign the static setting and the LAG number.
3
Toggle the button in the LACP row to
L
to aggregate the port to a LAG with LACP
4
Click
Apply Changes
.
The port is added to the LAG, and the device is updated.
Assigning Ports to LAGs Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning ports to LAGs as
displayed in the
LAG Membership
page.
Table 7-30. LAG Membership CLI Commands
CLI Command Description
interface port-channel
port-channel-number
Enters the interface configuration mode of a
specific port-channel.
channel-group
port-
channel-number
mode
{on | auto}
Associates a port with a port-channel. Use the
no form of this command to remove the
channel-group configuration from the
interface