Filter
Top Products
Configuring the Switch 87
Figure 5-4. Internet Protocol (TCP/IP) Properties Window
4
Click
Use the following IP address
.
5
Enter the appropriate addresses for the management station in the
IP address
,
Subnet mask
,
and
Default gateway
fields.
NOTE: If the management station is connected to a router and not directly to the 6024/6024F switch, the
default gateway must be configured as the router interface IP address connected to the management
station (which leads to the 6024/6024F switch).
Enabling Telnet Access
Use the Windows/DOS command line or a Telnet application to access the device via a Telnet.
Remember to enter the appropriate password. The connection is done with the IP address defined
on the device.
When access is granted, command usage is the same as in direct device management:
1
On the management station, click
Start
→
Run.
2
In the
Run
window, type
cmd
and click
OK
.
The standard Windows command line interface is displayed.