Filter
Top Products
356 Configuring Routing
www.dell.com | support.dell.com
Remove
— When checked, removes the IP address from the OSPF area table.
Defining a New OSPF Area
1
Open the
OSPF Areas
page.
2
Click
Add
to display the
Add an OSPF Area
page.
3
Complete the fields in the dialog.
NOTE: The Stub Metric field is defined for Area Border routers.
4
Click
Apply Changes
.
The new area is added to the OSPF area table.
Modifying OSPF Area Parameters
1
Open the
OSPF Areas
page.
2
Select an
Area ID
.
The parameters for the OSPF area display.
3
Modify the fields as desired.
4
Click
Apply Changes
.
The area parameters are modified and saved to the device.
Deleting an OSPF Area
1
Open the
OSPF Areas
page.
2
Click
Show All
to display the OSPF Area table
.
3
Select an OSPF area and check the
Remove
check box.
4
Click
Apply Changes
.
The OSPF area is removed from the table, and the device is updated.
Defining OSPF Areas Using CLI Commands
The following table contains the CLI commands for defining OSPF areas.
Table 8-9. OSPF Area CLI Commands
CLI Command Description
router ospf area
area-
id
stub
Defines an area as a stub area. To disable
this function, use the no form of this
command.
router ospf area
area-
id default-cost cost
Specifies a cost for the default summary
route sent into a stub area.