Filter
Top Products
Configuring the Switch 69
NOTE: Each part of the IP address must start with a number other than zero. For example, IP addresses
001.100.192.6 and 192.001.10.3 are invalid.
9
Press
Enter
.
Wizard Step 4
The following is displayed:
Finally, setup the default gateway. Please enter the gateway IP
address from which this network is reachable (e.g.
192.168.1.1):
10
Enter the default gateway.
11
Press
Enter
. The following is displayed (as per the example parameters described):
This is the configuration information that has been collected:
SNMP Interface = MYSETUPWIZARD@0.0.0.0
User Account setup = admin
Password = **********
Management IP address = 192.168.1.100 255.255.255.0
Default Gateway = 192.168.1.1
Wizard Step 5
The following is displayed:
If the information is correct, please select (Y) to save the
configuration, and copy to the start-up configuration file. If
the information is incorrect, select (N) to discard
configuration and restart the wizard: [Y/N]
12
Enter [N] to skip to restart the Setup Wizard or enter [Y] to complete the Setup Wizard. If
[Y] is entered the following is displayed:
Configuring SNMP management interface.
Configuring user account.......
Configuring IP and subnet......
...............................
Thank you for using Dell Easy Setup Wizard. You will now enter
CLI mode.
Wizard Step 6
The CLI prompt is displayed.