Filter
Top Products
304 Configuring Switch Information
www.dell.com | support.dell.com
Ingress Filtering
— Enables or disables Ingress filtering by the LAG. Ingress filtering discards
packets where the VLAN tag does not match any LAG VLAN.
Assigning VLAG Settings
1
Open the
VLAN LAG Settings
page.
2
Select a LAG from the
LAG
drop-down menu and complete the fields on the page.
3
Click
Apply Changes
.
The VLAN LAG parameters are defined, and the device is updated.
Displaying the VLAN LAG Table
1
Open the
VLAN LAG Settings
page.
2
Click
Show All
to display the
VLAN LAG Table
.
Assigning LAGs to VLAN Groups Using CLI Commands
The following table summarizes the equivalent CLI commands for assigning LAGs to VLAN
groups as displayed in the
VLAN LAG Settings
page.
Table 7-25. LAG VLAN Assignments CLI Commands
CLI Command Description
switchport mode
{access | trunk |
general}
Configures a port VLAN membership mode.
switchport trunk
native vlan
vlan-id
Defines the port as a member of the specified
VLAN, and the VLAN ID as the port default
VLAN ID (PVID).
switchport general
pvid
vlan-id
Configure the Port VLAN ID (PVID) when the
interface is in general mode.
switchport general
allowed vlan add
vlan-
list
[tagged |
untagged]
Adds or removes VLANs from a general port.
switchport general
acceptable-frame-type
tagged-only
Discards untagged packets at ingress.
switchport general
ingress-filtering
disable
Disables port ingress filtering.