Filter
Top Products
Configuring Switch Information 319
3
Click
Apply Changes
.
Bridge Multicast
is enabled on the device.
Enabling IGMP Snooping on the Device
1
Open the
Multicast Global Parameters
page.
2
Select
Enable
in the
IGMP Snooping Status
field.
3
Click
Apply Changes
.
IGMP Snooping is enabled on the device.
Enabling Multicast Forwarding and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast forwarding
and IGMP Snooping as displayed on the
Multicast Support
page.
The following is an example of the CLI commands:
Console (config)# bridge multicast filtering
Console (config)# ip igmp snooping
Adding Bridge Multicast Address Members
The
Bridge Multicast Group
page
displays the ports and LAGs attached to the Multicast service
group in the
Ports
and
LAGs
tables. The Port and LAG tables also reflect the manner in which the
port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new
Multicast service groups. The
Bridge Multicast Group
page
permits new multicast service groups
to be created. The
Bridge Multicast Group
page also
assigns ports to a specific multicast service
address group.
To open the
Bridge Multicast Group
page, click
Switch
→
Multicast Support
→
Bridge Multicast
Address
in the tree view.
Table 7-31. Multicast Forwarding and Snooping CLI Commands
CLI Command Description
bridge multicast
filtering
Enables filtering of Multicast addresses.
ip igmp snooping Enables Internet Group Membership
Protocol (IGMP) snooping.