Filter
Top Products
266 Configuring Switch Information
www.dell.com | support.dell.com
Modifying Storm Control Port Parameters
1
Open the
Storm Control
page.
2
Complete the fields on the page.
3
Click
Apply Changes
.
The storm control port parameters are saved to the device.
Copying Parameters in the Storm Control Settings Table
1
Open the
Storm Control
page.
2
Click
Show All
to display the
Storm Control Settings Table
.
3
Select the port from which you want to copy settings from the
Copy Parameters from Port
field.
4
Check the
Copy to
check box to define the interfaces to which the storm control definitions
are copied, or click
Select All
to copy the definitions to all ports.
5
Click
Apply Changes
.
The parameters are copied to the selected port ports in the
Storm Control Settings Table
,
and the device is updated.
Configuring Storm Control with CLI Commands
The following table summarizes the equivalent CLI commands for configuring Storm Control as
displayed on the
Storm Control
page.
The following is an example of the CLI commands:
Console(config)# port storm-control include-multicast
Console(config)# interface ethernet g1
Console(config-if)# port storm-control broadcast enable
Table 7-10. Storm Control CLI Commands
CLI Command Description
port storm-control
include-multicast
Enables the device to count multicast
packets together with broadcast packets.
port storm-control
broadcast enable
Enables broadcast storm control.
port storm-control
broadcast rate
rate
Configures the maximum broadcast rate.
show ports storm-control
port
Displays the storm control configuration.