Filter
Top Products
246 Configuring Switch Information
www.dell.com | support.dell.com
Figure 7-8. Add ACE to IP Based ACL
The
Add ACE to IP Based ACL
page contains the following fields:
ACL Name
— User-defined ACLs.
New ACE Priority
— ACE priority that determines which ACE is matched to a packet based on a
first-match basis.
Protocol
— Enables creating an ACE based on a specific protocol.
Select from List
— Click to select from a protocols list on which ACE can be based.
Protocol ID To Match
— Click to add a user-defined protocol by which packets are matched
to the ACE.
NOTE: Using "any" specifies that all IP protocols are selected.
Source Port
— The TCP/UDP source port. This field is active only if
800/6-TCP
or
800/17-UDP
are
selected in the
Select from List
drop-down menu.
Destination Port
— The TCP/UDP destination port. This field is active only if
800/6-TCP
or
800/17-UDP
are selected in the
Select from List
drop-down menu.
Source IP Address
—Matches the source port IP address to which packets are addressed to the
ACE.
Wild Card Mask
— Source IP address wildcard mask.Wild card masks specify which bits are used
and which bits are ignored. A wild card mask of 255.255.255.255 indicates that no bit is important.
A wildcard of 0.0.0.0 indicates that all the bits are important.
Dest. IP Address
— Matches the destination port IP address to which packets are addressed to the
ACE.