Filter
Top Products
90
4.7 Using the Network Settings Menus
4.7.1 Giving the Scanner an IP Address
An IP address must be set in order to connect the scanner to a network.
1. Select the [Network Settings] tab on the top menu.
2. Select the [IP Address] tab on the left side menu.
The DHCP or IP address setting screen appears.
3. Select whether or not a DHCP is required.
Set the scanner's IP address. This may be done automatically, by pressing the DHCP [On]
button. By default, this is set as [On].
The IP address may also be set manually, by pressing the DHCP [Off] button and entering
the following numerical addresses:
z IP Address
z Subnet Mask
z Default Gateway