Fujitsu FI-6010N Scanner User Manual


 
4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 97
4
10. Select whether to set the scanner as a Scanner Discovery target for the Central
Admin Server.
The default value is [On].
Press the [On] button to set the scanner as a Scanner Discovery target for the Central Admin
Server.
When enabled, the scanner is registered by Scanner Discovery as a scanner to be centrally
administered by Central Admin Server.
Press the [Off] button to remove the scanner as a Scanner Discovery target for the Central
Admin Server.
11. When targeting the scanner for Scanner Discovery, enter the Discovery ID for the
destination Central Admin Server in [Discovery ID].
The Discovery ID may be up to 100 characters long.
Alphanumeric characters and symbols can be used. Note that the Discovery ID is case
sensitive.
When the Discovery ID set in Central Admin Server and the Discovery ID set here match,
the scanner is targeted for central administration.
12. Press the [OK] button.
The "Central Admin Server" screen is shown again.
13. Press the [OK] button.
The Central Admin Server settings are set.
The scanner information is transmitted to the Central Admin Server.
If the process is successful, the text will change to "This scanner's server-side status is:
Registered".
HINT
For the Admin Tool, there is no [Details] button. The scanner discovery
and discovery ID can be set in the same window.
HINT
z For details about the settings required to use SSL for communication between
the Central Admin Server and scanner, refer to "4.7.2 Setting the Admin Net-
work" (page 92).
z When user roaming or job settings enabled, if communication with the Central
Admin Server is not possible a confirmation message will appear at login.
If [OK] is selected, the settings information saved in the scanner are used.
Selecting the [Cancel] button returns to the login screen.