Filter
Top Products
4.11 Setting Job Features
fi-6010N Network Scanner Operator's Guide 213
4
3. Enter the job menu name.
This may be up to 64 characters long.
4. Select the line corresponding to the job button position (1) to (6), and select the [Edit]
button.
The "Job Button Settings" window appears.
5. Enter the job button name.
This may be up to 32 characters long.
6. In the [Select Button Pixmap] drop-down list box, select a job button pixmap.
The selected job button pixmap is inserted into the job button mockup image on the right,
allowing the resulting button design to be checked.
7. To start the Add-in module when the job button is pressed, select the Add-in module
to be started from [Add-in].
If an Add-in module is selected, the Add-in module is assigned to the job button, rather than
the job sequence. The "Job Button Name" and "Select Button Pixmap" are ignored. The but-
ton specified by the Add-in module appears in the Job Menu.
ATTENTION
If an Add-in module is not installed in the scanner, it cannot be
selected.