Filter
Top Products
5 - 61
CDMA
Use the CDMA tab to activate the Thor VM2 for use with a CDMA carrier such as Verizon. This step is not necessary
for carriers using a SIM card.
The Serial Number, IMEI (International Mobile Equipment Identity) and MEID (Mobile Equipment ID) numbers are dis-
played on this tab as the carrier may request this information when setting up an account.
Activation Type
There are two activation methods, Automatic and Manual.
Automatic Activation
1. Select the Automatic radio button for Activation Type.
2. Automatic activation requires an Activation Code. Enter the Activation Code in the Activation Code text
box
3. Tap Save Connection Data.
4. Tap Activate.
5. All other text boxes are grayed out as no additional entries are required for automatic activation.
6. Verify the activation process is successful by reviewing the message below the Activate button.
Manual Activation
1. Select the Manual radio button for Activation Type.
2. Enter the Service Programming Code, System Identification number, Mobile Directory number and
Mobile Identification Number in the appropriate text boxes. The Activation Code text box is not used.
3. Tap Save Connection Data.
4. Tap Activate.
5. Verify the activation process is successful by reviewing the message below the Activate button.
Autoconnect
When checked, Autoconnect is enabled. The Connection Manager automatically connect when necessary, such
as when Internet Explorer is launched.
Data Connection Test
Tap the Connect button to make a temporary test connection to validate the carrier account.
Entries identified with an asterisk (*) are used to configure the test connection.
Tap the Save Connection Data button to save the connection parameters.