Filter
Top Products
5 - 92
Stylus
Start > Settings > Control Panel > Stylus
Use this control panel option to set stylus double-tap sensitivity properties and calibrate the Thor VM2 touch panel when
needed.
Double-Tap
Follow the instructions on the screen and tap the OK button to save any double-tap changes.
Calibration
Calibration involves tapping the center of a target. If you miss the center, keep the stylus on the screen, slide it over
the target's center, and then lift the stylus.
To begin, tap the Recalibrate button on the screen with the stylus. Press and hold the stylus on the center of the tar-
get as it moves around the screen. Press the Enter key to keep the new calibration setting or press the Esc key to
revert to the previous calibration settings.
Note: If the touch screen looses calibration on a Thor VM2, you must use a USB mouse or keyboard attached to the
Thor VM2 to access this tab to recalibrate the touch screen unless a Programmable Key (page 5-83) has been
assigned to launch the calibration utility.