Filter
Top Products
5 - 77
Password
Start > Settings > Control Panel > Password
Use this panel to set Thor VM2 user access to control panels and power up password properties.
Important: This password must be entered before performing a Load Factory Defaults.
If entering a power-on or screen saver password does not allow you to disable this password protection or perform a Load
Factory Defaults, contact Technical Assistance (page 11-1).
Factory Default Settings
• The password and password settings are saved during a warm boot and a restart.
• The screensaver password affects the Remote Desktop screensaver only.
• After a password is assigned and saved, each time a Settings > Control Panel option is selected, the user will be
required to enter the password before the Control Panel will open.
• The screensaver password is the same as the power-on password. They are not set independently.
• A screensaver password cannot be created without first enabling the “Enable password protection at power-on”
checkbox.
• The screensaver password is not automatically enabled when the “power-on” checkbox is enabled.
Enter the password in the Password text box, then press Tab and type the password again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox.
A changed/saved password is in effect immediately.
PC Connection
Start > Settings > Control Panel > PC Connection
Use these options to control a cabled connection (USB, serial) between the Thor VM2 and a nearby desktop/laptop com-
puter.
Factory Default Settings
Tap the Change button to change the direct connect setting.
Password Blank
Enter password at Power On Disabled
Enter password at Remote Desktop Screen Saver Disabled
Enable direct connection Enabled
Connect using USB Client