Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
101
After configuring BGP to enable the error debug flag, it may print following information when an error happens:
BGP: 10.1.1.1-10.2.2.2, NHop Validate: Invalid NHop address 250.3.0.0/8 received.
BGP: Hold-Timer: Invalid Peer.
debug bgp show global_info
Purpose This command is used to display global information of the current BGP instance.
Syntax
debug bgp show global_info
Description This command is used to display global information of the current BGP instance.
Parameters None.
Restrictions Only Administrator level users can issue this command.
Example usage:
Configure BGP to show global information:
DGS-3627:admin# debug bgp show global_info
Command: debug bgp show global_info
Following is the information for global debugging:
---------------------------------------------------
AS Number : 10000
Router ID : 192.168.60.105
Cluster ID : 0.0.0.0
Confed ID : 0
Confederation peers :
Fast External Fallover : Enabled
Graceful Restart : Disabled
Restart Time : 120 Seconds
Stalepath Time : 360 Seconds
Update Delay Time : 120 Seconds
Dampening ability : Disabled
Client to Client ability : Enable
Cluster peers are:
Aggregate Next_Hop_Check : Disabled
Default Local Preference : 100
Default Holdtime : 180
Default Keepalive : 60
Scan Time : 60
BGP active flag:
BGP active af-flag is:
BGP_AF_CFLAG_NETWORK_SYNC
note: address family is IPv4 Unicast
BGP active Redist-Flags:
note: The address family is IPv4
BGP Trap : None
DGS-3627:admin#