Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
741
enable wac
Description The enable wac command enables WAC function.
WAC and JWAC are mutual exclusive function. That is, they can not be enabled at the same
time.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable WAC:
DGS-3627:admin# enable wac
Command: enable WAC
Success.
DGS-3627:admin#
disable wac
Purpose Used to disable WAC function.
Syntax
disable wac
Description The disable wac command disables WAC function; all authentication entries related to WAC
will be deleted.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable WAC:
DGS-3627:admin# disable wac
Command: disable wac
Success.
DGS-3627:admin#
config wac ports
Purpose Used to config state and other parameters of the ports.
Syntax
config wac ports [<portlist> | all] {state [enable | disable] | aging_time [infinite | <min 1-
1440>] | idle_time [infinite | <min 1-1440>] | block_time [<sec 0-300>]}(1)
Description The config wac ports command allows you to configure port state and other parameters of
WAC.
The default value of aging time is 1440 minutes.
The default value of idle time is infinite.
The default value of block_time is 60 seconds.
Parameters
portlist - A port range to set their WAC state.
all - All the Switch ports’ WAC state is to be configured.
state - To specify the port state of WAC