Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
408
DGS-3627:admin# create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3627:admin#
delete link_aggregation group_id
Purpose Used to delete a previously created link aggregation group.
Syntax
delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link aggregation group.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32 link aggregation groups to be
configured. The group number identifies each of the groups.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To delete link aggregation group:
DGS-3627:admin# delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3627:admin#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enable | disable]
Description
This command allows users to configure a link aggregation group that was created with the create
link_aggregation command above.
Parameters
group _id <value 32> − Specifies the group ID. The Switch allows up to 32 link aggregation groups
to be configured. The group number identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of the link aggregation
group will be the master port. All of the ports in a link aggregation group will share the port
configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link aggregation group
including the master port. The beginning and end of the port list range are separated by a dash.
Non-contiguous portlist entries are separated by a comma. (ex: 1-3,7-9)
state [enable | disable] − Allows users to enable or disable the specified link aggregation group.
Restrictions Only Administrator and Operator-level users can issue this command. Link aggregation groups
may not overlap.