Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
556
DGS-3627:admin# show pim static_rp
Command: show pim static_rp
PIM Static RP Table
Group RP Address
------------------ --------------------
224.0.0.0/4 11.1.1.254
239.0.0.1/32 31.1.1.1
239.0.0.2/32 31.1.1.12
239.0.0.3/32 31.1.1.123
Total entries: 4
DGS-3627:admin#
config pim last_hop_spt_switchover
Purpose Used to choose the switchover mode on the last hop router.
Syntax
config pim last_hop_spt_switchover [never | immediately]
Description This command will configure the need to change the last hop router’s distribution tree to a SPT.
The last hop router will always receive data from the shared tree unless this command is
changed to immediately and then the router will always receive multicast data from the shortest
path tree. This command is for PIM-SM configurations only.
Parameters
never – Using this command will configure the router to always receive multicast data from the
shared tree.
immediately – Using this command will configure the router to always receive multicast data
from the shortest path tree.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the last hop router to immediately switch to SPT:
DGS-3627:admin# config pim last_hop_spt_switchover immediately
Command: config pim last_hop_spt_switchover immediately
Success.
DGS-3627:admin#
show pim rpset
Purpose Used to display the RP Set of the Switch.
Syntax
show pim rpset
Description This command will display the information regarding the RP Set learned by the BSR and
statically configured by the user. This command is for PIM-SM configurations only.
Parameters None.
Restrictions None.
Example usage:
To view the RP Set information: