Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
5
In the above example, the command config account was entered without the required parameter <username>, the CLI
returned the Next possible completions: <username> prompt. The up arrow cursor control key was pressed to re-
enter the previous command (config account) at the command prompt. Now the appropriate username can be entered
and the config account command re-executed.
All commands in the CLI function in this way. In addition, the syntax of the help prompts are the same as presented in this
manual − angle brackets < > indicate a numerical value or character string, braces { } indicate optional parameters or a
choice of parameters, and brackets [ ] indicate required parameters.
If a command is entered that is unrecognized by the CLI, the top-level commands will be displayed under the Available
commands: prompt.
DGS-3627:admin# the
Available commands:
.. ? cable_diag cd
clear config copy create
debug delete dir disable
download enable erase login
logout no ping ping6
reboot reconfig rename reset
save show telnet traceroute
traceroute6 upload
DGS-3627:admin#
Figure 2- 5. Available Commands
The top-level commands consist of commands such as show or config. Most of these commands require one or more
parameters to narrow the top-level command. This is equivalent to show what? or config what? Where the what? is the
next parameter.
For example, if you enter the create command with no additional parameters, the CLI will then display all of the possible
next parameters.
DGS-3627:admin# create
Command: create
Next possible completions:
802.1x access_profile account address_binding
arpentry authen authen_enable authen_login
authentication bgp cpu dhcp
dhcpv6 dot1v_protocol_group double_vlan
erps fdb host_name igmp_snooping
ip ip_tunnel ipif ipmroute
iproute ipv6 ipv6route jwac
link_aggregation loopback mac_based_access_control
mac_based_access_control_local mac_based_vlan md5
mirror multicast_fdb multicast_range nlb
ospf ospfv3 pim policy_route
route route_map rspan sflow
snmp stp subnet_vlan super_vlan
syslog trusted_host vlan vlan_translation
vrrp wac
DGS-3627:admin#
Figure 2- 6. Next possible completions: Create command
In the above example, all of the possible next parameters for the create command are displayed.