Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
436
Example usage:
To disable MAC notification without changing basic configuration:
DGS-3627:admin# disable mac_notification
Command: disable mac_notification
Success.
DGS-3627:admin#
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>}
Description MAC address notification is used to monitor MAC addresses learned and entered into the FDB.
Parameters
interval <sec 1-2147483647> – The time in seconds between notifications. The user may
choose an interval between 1 and 2,147,483,647 seconds.
historysize <1-500> – The maximum number of entries listed in the history log used for
notification.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the Switch’s MAC address table notification global settings:
DGS-3627:admin# config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3627:admin#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist> | all] [enable | disable]
Description MAC address notification is used to monitor MAC addresses learned and entered into the
FDB.
Parameters
<portlist> – Specify a port or range of ports to be configured. The beginning and end of the
port list range are separated by a dash. Non-contiguous portlist entries are separated by a
comma. (ex: 1-3,7-9)
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC address table notification on
the Switch.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable port 7 for MAC address table notification: