Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
607
79
SAFEGUARD ENGINE COMMANDS
Periodically, malicious hosts on the network will attack the Switch by utilizing packet flooding (ARP Storm) or other
methods. These attacks may increase the CPU utilization beyond its capability. To alleviate this problem, the Safeguard
Engine function was added to the Switch’s software.
The Safeguard Engine can help the overall operability of the Switch by minimizing the workload of the Switch while the
attack is ongoing, thus making it capable to forward essential packets over its network in a limited bandwidth. When the
Switch either (a) receives too many packets to process or (b) exerts too much memory, it will enter an Exhausted mode.
When in this mode, the Switch will perform the following tasks to minimize the CPU usage:
• It will limit bandwidth of receiving ARP packets. The user may implement this in two ways, by using the config
safeguard_engine command.
o When strict is chosen, the Switch will stop receiving ARP packets not destined for the Switch. This will
eliminate all unnecessary ARP packets while allowing the essential ARP packets to pass through to the
Switch’s CPU.
o When fuzzy is chosen, the Switch will minimize the ARP packet bandwidth received by the switch by
adjusting the bandwidth for all ARP packets, whether destined for the Switch or not. The Switch uses an
internal algorithm to filter ARP packets through, with a higher percentage set aside for ARP packets
destined for the Switch.
• It will limit the bandwidth of IP packets received by the Switch. The user may implement this in two ways, by
using the config safeguard_engine command.
o When strict is chosen, the Switch will stop receiving all unnecessary broadcast IP packets, even if the
high CPU utilization is not caused by the high reception rate of broadcast IP packets.
o When fuzzy is chosen, the Switch will minimize the IP packet bandwidth received by the Switch by
adjusting the bandwidth for all IP packets, by setting a acceptable bandwidth for both unicast and
broadcast IP packets. The Switch uses an internal algorithm to filter IP packets through while adjusting
the bandwidth dynamically.
IP packets may also be limited by the Switch by configuring only certain IP addresses to be accepted. This method can
be accomplished through the CPU Interface Filtering mechanism explained in the previous section. Once the user
configures these acceptable IP addresses, other packets containing different IP addresses will be dropped by the Switch,
thus limiting the bandwidth of IP packets. To keep the process moving fast, be sure not to add many conditions on which
to accept these acceptable IP addresses and their packets, this limiting the CPU utilization.
Once in Exhausted mode, the packet flow will decrease by half of the level that caused the Switch to enter Exhausted
mode. After the packet flow has stabilized, the rate will initially increase by 25% and then return to a normal packet flow.
NOTICE: When the Safeguard Engine is enabled, the Switch will allot bandwidth to various traffic
flows (ARP, IP) using the FFP (Fast Filter Processor) metering table to control the CPU utilization and
limit traffic. This may limit the speed of routing traffic over the network.
The Safeguard Engine commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config safeguard_engine {state [enable | disable] | utilization {rising <value 20-100> | falling <value 20-
100>} | trap_log [enable | disable] | mode [strict | fuzzy]}
show safeguard_engine
Each command is listed, in detail, in the following sections.