Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
702
DGS-3627:admin# config traffic control 1-12 broadcast enable action shutdown threshold 1
countdown 5 time_interval 10
Command: config traffic control 1-12 broadcast enable action shutdown threshold 1
countdown 5 time_interval 10
Success.
DGS-3627:admin#
config traffic trap
Purpose Used to configure trap modes.
Syntax
config traffic trap [ none | storm_occurred | storm_cleared | both ]
Description
Occurred Mode: This trap is sent when a packet storm is detected by the packet storm
mechanism.
Cleared Mode: This trap is sent when the packet storm is cleared by the packet storm
mechanism.
Parameters
none - No trap state is specified for storm control.
storm_occurred - Occurred mode is enabled and cleared mode is disabled.
storm_cleared - Occurred mode is disabled and cleared mode is enabled.
both - Both occurred and cleared modes are enabled.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable both the occurred mode and cleared mode traffic control traps:
DGS-3627:admin# config traffic trap both
Command: config traffic trap both
Success.
DGS-3627:admin#
show traffic control
Purpose Used to display the current traffic control settings.
Syntax
show traffic control { <portlist>}
Description The show traffic control command displays the current traffic control settings.
Parameters
portlist - Used to specify the range of ports to be shown.
If no parameter is specified, the system will display the packet storm control configuration for
all ports.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To display the traffic control parameters for ports 1 to 10: