Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
416
config lldp tx_delay
Purpose Used to change the minimum time (delay-interval) LLDP ports will delay in advertising
successive LLDP advertisements due to a change in LLDP MIB content. The tx_delay
defines the minimum interval between sending of LLDP messages due to constantly change
of MIB content.
Syntax
config lldp tx_delay < sec 1–8192 >
Description The LLDP message_tx_interval (transmit interval) must be greater than or equal to (4 x
tx_delay interval).
Parameters
tx_delay – The range is from 1 second to 8192 seconds. The default setting is 2 seconds.
NOTE: txDelay should be less than or equal to 0.25 * msgTxInterval
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the delay interval:
DGS-3627:admin# config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DGS-3627:admin#
config lldp reinit_delay
Purpose Change the minimum time of the reinitialization delay interval.
Syntax
config lldp reinit_delay <sec 1 - 10>
Description A re-enabled LLDP port will wait for reinit_delay after last disable command before
reinitializing.
Parameters
reinit_delay – The range is from 1 second to 10 seconds. The default setting is 2 seconds.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To changes the re-initialization delay interval to five seconds:
DGS-3627:admin# config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DGS-3627:admin#