Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
602
debug ripng state
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable RIPng debug globally:
DGS-3627:admin# debug ripng state enable
Command: debug ripng state enable
Success.
DGS-3627:admin#
debug ripng show flag
Purpose This command is used to display the RIPng debug flag setting.
Syntax
debug ripng show flag
Description Used to display the RIPng debug flag setting.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To show the current RIPng debug flag setting:
DGS-3627:admin# debug ripng show flag
Command: debug ripng show flag
Current Enabled RIPng Flags:
Interface State Change
Packet Receiving
Packet Sending
Route
DGS-3627:admin#
debug ripng flag
Purpose This command is used to enable or disable the RIPng debug flag .
Syntax
debug ripng flag [{interface | packet [all | rx | tx] | route}(1) | all] state [enable | disable]
Description Used to enable or disable the RIPng debug flag.
Parameters
interface - The state of the RIPng interface debug. The default setting is disabled.
packet - See below:
all - Set all packets with debug flags.
rx - Set inbound packets with debug flag.
tx - Set outbound packets with debug flag.
route - The state of the RIPng route debug. The default setting is disabled.
all - Set all debug flags.
state - See below:
enable - Enable the designated flags.