Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
514
DGS-3627:admin# show ospf all
Command: show ospf all
Interface Name: System IP Address: 10.90.90.90/8 (Link Up)
Network Medium Type: BROADCAST Metric: 1
Area ID: 0.0.0.0 Administrative State: Disabled
Priority: 1 DR State: DOWN
DR Address: None Backup DR Address: None
Hello Interval: 10 Dead Interval: 40
Transmit Delay: 1 Retransmit Time: 5
Authentication: None
Total Entries : 1
DGS-3627:admin#
create ospf virtual_link
Purpose Used to create an OSPF virtual interface.
Syntax
create ospf virtual_link <area_id> <neighbor_id> {hello_interval <sec 1-65535> |
dead_interval <sec 1-65535> | authentication [none | simple <password 8> | md5 <key_id
1-255>]}
Description This command is used to create an OSPF virtual interface.
Parameters
<area_id> − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely
identifies the OSPF area in the OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is a 32-bit number in the form of
an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the remote area’s Area Border Router.
The router ID of the neighbor router.
hello_interval <sec 1-65535> − Allows the specification of the interval between the transmission
of OSPF Hello packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello
Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all
routers on the same network.
dead_interval <sec 1-65535> − Allows the specification of the length of time between the receipt
of Hello packets from a neighbor router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly
divisible by the Hello Interval.
authentication – Enter the type of authentication preferred. The user may choose between:
• none – Choosing this parameter will require no authentication.
• simple <password 8> − Choosing this parameter will set a simple authentication which
includes a case-sensitive password of no more than 8 characters.
• md5 <key_id 1-255> − Choosing this parameter will set authentication based on md5
encryption. A previously configured MD5 key ID (1 to 255) is required.
Restrictions Only Administrator and Operator-level users can issue this command.
Usage example
To create an OSPF virtual interface:
DGS-3627:admin# create ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Command: create ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Success.
DGS-3627:admin#