Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
507
config ospf host_route
Restrictions Only Administrator and Operator-level users can issue this command.
Usage example
To configure an OSPF host route:
DGS-3627:admin# config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Command: config ospf host_route 10.48.74.122 area 10.1.1.1 metric 2
Success.
DGS-3627:admin#
show ospf host_route
Purpose Used to display the current OSPF host route table.
Syntax
show ospf host_route {<ipaddr>}
Description This command will display the current OSPF host route table.
Parameters
<ipaddr> − The IP address of the host.
Restrictions None.
Example usage:
To display the current OSPF host route table:
DGS-3627:admin# show ospf host_route
Command: show ospf host_route
OSPF Host Route Settings
Host Address Metric Area ID
--------------- ------ ---------------
10.48.73.21 2 10.1.1.1
Total Entries : 1
DGS-3627:admin#
create ospf aggregation
Purpose Used to configure OSPF area aggregation settings.
Syntax
create ospf aggregation <area_id> <network_address> lsdb_type [summary {advertise
[enable | disable]} | nssa_ext {advertise [enable | disable]}]
Description This command is used to create an OSPF area aggregation.
Parameters
<area_id> − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
<network_address> − The 32-bit number in the form of an IP address that uniquely identifies the
network that corresponds to the OSPF Area.
lsdb_type − The type of address aggregation. The user has two choices for the LSDB type:
• summary – Choosing this LSDB type will summarize routes that are entering the OSPF
area by redistribution.