Filter
Top Products
xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
487
config ospfv3 router_id
Parameters
router_id - User may enter a 32-bit number in the form of an IPv4 address that uniquely
identifies the router in the OSPFv3 domain. Set 0.0.0.0 means auto-selected. Switch will
select the largest IPv4 address among the IP interfaces to be the router ID. The default value
of OSPFv3 router ID is 0.0.0.0 (auto-selected).
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To set OSPFv3 router ID:
DGS-3627:admin# config ospfv3 router_id 1.1.1.1
Command: config ospfv3 router_id 1.1.1.1
Success.
DGS-3627:admin#
enable ospfv3
Purpose Used to enable OSPFv3 on the switch.
Syntax
enable ospfv3
Description This command is used to enable OSPFv3 on the switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To enable OSPFv3:
DGS-3627:admin# enable ospfv3
Command: enable ospfv3
Success.
DGS-3627:admin#
disable ospfv3
Purpose Used to disable OSPFv3 on the switch.
Syntax
disable ospfv3
Description This command is used to disable OSPFv3 on the switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable OSPFv3: